2 CTS Short Shaft 500k Audio Taper Push/Pull Pots

0 Review(s) Write a Review

Your Price: $22.95

Retail Price:$32.95

You Save:$10.00(30%)

Part Number: 2-EP-5586-000

Availability: Shipping Calculated at Checkout

Quantity

Description

Set of 2 brand new CTS 500K SHORT SPLIT shaft audio taper push/pull potentiometer DPDT (double pole/double throw). The switch contacts are on the side, not the back. This makes them shorter, so they'll fit most guitars without further routing. They are also one of the easiest push-pulls to wire up. You just need to strip 1/8" of insulation from the end of the wire, push the bare wire into one of the numbered holes and solder it.

Can be used for series/parallel wiring, coil splitting and phase reversal. These are short shaft pots and fit PRS Epiphone, Imports and many other USA guitars (threaded bushing is 3/8" tall & 3/8" diameter)

Includes 2 nuts, lock washer & dress washer on each Pot. The split shafts require a 24-spline knob.

PLEASE NOTE. These Pots need a 3/8" diameter hole for installation. Most Epiphones and Import Guitars have a smaller hole of 8mm as standard in the guitar body, so there is a good chance that you will have to enlarge the 4 pot holes in the body to 3/8".

Also, Epiphone and Import Knobs (18 spline) won't fit USA spec pots (24 spline) like CTS, so you will most likely need new knobs.